LS Industrial Systems G3L-RUEA - High-Speed Link Setting of KGLWIN

Chapter 6. Communication Function
6-10
Note
1) Run-link monitoring
If GRL-TR4A that is one of the Smart I/O is set in the parameter, run-link is always
indicated as ‘0’.
6.1.4 High-speed link setting of KGLWIN
1) KGLWIN’s project and link parameter
High-speed link parameter can be set by selecting the link parameter on the project screen of
KGLWIN. The setting sequence and function per each item is as follows.
(1) Setting the project of KGLWIN
The following figure is parameter basic screen invoked when selecting the parameter window.
KGLWIN parameter basic screen (in case of K200S)
(2) Link parameter basic setting
If you select Link1 on the KGLWIN parameter basic screen, The following high-speed link 1
parameter basic screen shows.