Chapter 6. Communication Function
6-29
2) If remote connection is made with K1000S/K300S/K200S remote I/O, following items are not performed.
(1) Writing of program and each parameter
(2) Reading of program and each parameter
(3) Operation performed with direct relation to program
* Time chart monitor of monitor
* Link parameter of monitor
* High speed link monitor
* Forced I/O information
* Link enable setting
* Flash memory
* Link information
* Mode conversion
(4) Link enable setting
(5) Rnet parameter, Rnet information
6.2.5 System flag for remote module
Information saved in the inner memory of remote module can be monitored by RSM’s flag monitor and
HS link and communication command execution information can be known easily by flag.
To Next Page
Loading...
