LS Industrial Systems SV iC5 Series - Basic Functions; Frequency Mode

9. Basic functions
9-1 SV-iC5
9. Basic Functions
9.1 Frequency mode
 Digital Frequency setting via Keypad 1
Group LED Display Parameter Name
Set
Value
Min/Max
Range
Factory
Defaults
Unit
Drive
group
0.0 [Frequency Command] - 0/400 0.0 Hz
Frq [Frequency mode] 0 0/8 0
 Run frequency is settable in 0.0 - [Frequency Command].
 Set Frq – [Frequency mode] to 0 {Frequency setting via Keypad 1}.
 Set the desired frequency in 0.0 and press the Prog/Ent () key to enter the value into memory.
 The value is settable not greater than F21 – [Max frequency].
 Digital Frequency setting via Keypad 2
Group LED Display Parameter Name
Set
Value
Min/Max
Range
Factory
Defaults
Unit
Drive
group
0.0 [Frequency Command] - 0/400 0.0 Hz
Frq [Frequency mode] 1 0/8 0
 Run frequency is settable in 0.0 - [Frequency Command].
 Set Frq – [Frequency mode] to 1{Frequency setting via Keypad 2}.
 In 0.0, frequency is changed upon pressing the Up ()/Down () key. It is seleted to use the Up/Down key as
potentiometer on keypad.
 The value is settable not greater than F21 – [Max frequency].