LS Industrial Systems SV iC5 Series User Manual

5. Programming keypad
5-3 SV-iC5
5.3 Moving to other groups
 There are 4 different parameter groups in SV-iC5 series as shown below.
Drive group Basic parameters necessary for the inverter to run. Parameters such as Target
frequency, Accel/Decel time are settable.
Function group 1 Basic function parameters to adjust output frequency and voltage.
Function group 2 Advanced function parameters to set parameters for such as PID Operation
and second motor operation.
I/O (Input/Output)
group
Parameters necessary to make up a sequence using Multi-function
input/output terminal.
 Moving to other parameter groups is only available in the first code of each group as
the figure shown below.
Moving to other groups using the Right () key Moving to other groups using the Left (⊳) key
Function
group 1
Function
group 2
I/O group
Drive group
*
Function
group 1
Function
group 2
I/O group
Drive group
*
* Target frequency can be set at 0.0 (the 1
st
code of drive group). Even though the preset value is 0.0, it is user-settable.
The changed frequency will be displayed after it is changed.
I/O group
Function
group 1
Drive group
Function
group
2

LS Industrial Systems SV iC5 Series Specifications

General

Brand	LS Industrial Systems
Model	SV iC5 Series
Category	Inverter
Language	English