LS tractor MT125 User Manual

5 -14
(1) Lubricating grease
z Threads, pin-connection parts and other sliding or
moving parts.
5-6. Every 50 hour check
▶ The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling port and then open the cap.
Caution
TM oil gauge
(2) Cleaning of Radiator and Radiator screen
z (See page 5-10)
(3) Checking Transmission oil
z Stop the tractor on level surface and apply the
parking brake and lower implements to the
ground.
z Clean around oil filling inlet and pull the gauge
straight out.
z Check If the oil level is between MAX and MIN of
oil gauge. If necessary, add new oil.
z For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.

LS tractor MT125 Specifications

General

Engine Power	24.7 HP
Transmission	Hydrostatic
Drive	4WD
Transmission Speeds	Infinite (2-range)
PTO Speed	540 RPM
Hydraulic System	Open center
3-Point Hitch	Category I
Tire Size (Front)	18x8.5-10
Tire Size (Rear)	26x12-12
Engine Type	Diesel
Fuel Capacity	6.6 gal