5 -27
(2) Fuse & Main fuse
① Fuse check and replacement
z How to replace the fuse
1. Unscrew the knobs in the right figure and remove
the rear cover for maintenance.
2. The fuse box is installed on the main wiring
harness and located in the left side of the
steering support.
2. Check each fuse and remove the damaged fuse.
3. Replace the new one same as damaged one.
z Capacity and function of each fuse is described
on the fuse box cover.
F2
F3
F4
F1
Fuse Location
Fuse
Capacity
Circuit
HST
F1 15A Head lamps
F2 20A Work lamp(opt.) / Combination lamp
F3 30A PTO solenoid valve
F4 10A Hazard warning lights
F5 30A Driver Solenoid
Rear cover
Knobs
▶ If the same function fuse is damaged repeatedly, contact your authorized dealer for
check. Do not use any alternatives such as wire or aluminum foil.
▶ If using an alternative instead of the rated capacity fuse, it may cause fire which
results in the damage of tractor or injury.
Notice
Fuse holder
F5
Electric
main
harness
To Next Page
Loading...
