5 -15
(4) Checking Front axle oil
z Turn the oil gauge counter-clockwise and pull it
up.
z Check If the oil level in the gauge scale is in
between the maximum and minimum mark.
z If necessary, add new oil into the oil filling port.
(after 5~10 minutes later, check the oil level
again)
z
For oil specification, see section 5-3, “Lubricants
and Capacity” or the last page in this manual.
(5) Battery check
z Refer to the section 5-12-(3), “Battery handling and Notices” in this manual. (See page 5-29)
(6) Air cleaner (Dry type)
z (See page 5-9)
Oil gauge
(7) Hydraulic hoses and Leakage
z Stop the engine and place all the transmission
gears in neutral and lower down the implement to
the ground.
z Periodically check hydraulic system for leaks or
damaged parts - kinked, crushed, flattened, hard
blistered, heat cracked, charred, twisted, soft or
loose covered hoses and fittings.
z Before removing hydraulic components, make
sure to check that hydraulic pressure is relieved
completely. The leaks of pressurized oil can
cause a fatal physical injury. For further
information, refer to the section, “3-3. Hydraulic
system” in this manual.
To Next Page
Loading...
Need help?
General
