4 -9
(6) Parking
z Stop the tractor on a level surface, not on a slope.
z Disengage PTO and place all the transmission
gear levers in NEUTRAL position and apply the
parking brake.
z Lower down the implements on the ground.
z Stop the engine and remove ignition key.
z Before you leave the operator’s station, wait for
engine and all the moving parts to stop.
▶If it is necessary to park the tractor on a slope, furthermore with loaded trailer, the
tractor may roll down, even though the parking brake is applied. In this case, apply
the gear in low speed and apply the chocks or blocks to all the tire.
- HST Type : place the range gear shift lever to the lowest speed.
Caution
Caution
▶DO NOT depart from the tractor with the transmission gear placed in neutral and
the parking brake is not applied. In neutral position, the tractor may roll. Apply the
parking brake at all times before leaving the tractor.
To Next Page
Loading...
