LSC maXim - Copying a Stack; Removing (Deleting) a Stack; Clearing the Stack Master

maXim Operator Manual Stacks
LSC Lighting Systems (Aust) Pty. Ltd. Page 46 of 66
11.5 COPYING A STACK
Any stack may be copied to any other bank/page/[F/A] number.
To copy a stack press;
[assign/copy] The display reads “Pick memory to copy from”.
If the source is not in the current red or blue pages, use the red or blue page buttons to select the
source bank page number.
When the source stack number F/A button is pressed, the display will briefly scroll,
“Pick location to copy to”.
Use the red or blue page buttons and the scene F/A buttons to select the destination page and
stack number.
Memories containing stacks flash slowly. Memories containing scenes are lit. Memories containing
chases flash rapidly. Empty memories are not lit. This acts as a warning to you of existing chase,
stack and scene numbers in each page.
When the destination stack number F/A button is pressed, the display will briefly confirm the source
and destination of the copy.
Note; When you make a copy of a stack, any stack (or chase or scene) that is currently in the
destination number will be overwritten by the copy.
The copy process may be abandoned at any time prior to entering the destination scene number by
pressing;
[assign/copy] a second time. That is, deselecting it.
Hint: If you have recorded a stack and you want to experiment with some changes, make a copy of
the stack and edit the copy. In the event that your changes are unsatisfactory, the original remains
unaltered.
11.6 REMOVING (DELETING) A STACK
To remove (delete) a stack from memory, press;
[remove]
If required, repeatedly press [red page] or [blue page] until the required page number is displayed,
then press;
[F/A] (stack number) of the stack to be removed.
The display asks you to confirm your action. Press [yes].
11.7 CLEARING THE STACK MASTER
To remove (clear) a stack from the stack master, press;
[remove]
[stack flash].
The display asks you to confirm your action. Press [yes].