LSC maXim - Page 6

[<] Deselects Bounce mode (runs reverse).
Hold [Step/stop], Tap [>] Selects SINGLE SHOT mode.
[>] If [>] is flashing, it runs a Single Shot in the forward direction.
If [<] is flashing, it snaps the chase to the first step and flashes [>] in preparation to running a
forward single shot.
[<] If [<] is flashing, it runs a Single Shot in the reverse direction.
If [>] is flashing, it snaps the chase to the last step and flashes [<] in preparation to running a
reverse single shot.
Hold [Step/stop], Tap [>] De-selects single shot mode and enters stop mode.
Hold [>], Tap [<] also De-selects single shot and enters Bounce mode.
When finished, press [select] or [edit] (to de-select it).
RECORD A STACK
To record a stack, press
[record stack]
[page] (optional) (select a page in either the red or blue banks)
[F/A] (stack number) (any of the red bank or blue bank flash/assign buttons) (or the grab F/A button on S & M models
only).
Each step of a stack consists of a either a previously recorded scene, chase or a snapshot of the maXim output.
To add a scene or chase as a step press
[page] (optional)
[F/A] (scene or chase number) (any of the red bank or blue bank flash/assign buttons)..
The fade times from the scene will be used for the step in the stack.
To record a snapshot (of the current maXim output) as a step press
[record scene].
As each step is added, you can repeatedly press [function] to set the fade IN time, fade OUT time and LINK time
(automatically links to next step after link time expires).
Pressing [function] again shows the current step number and allows you to record the next step.
Continue to record steps as above.
When all steps have been recorded, complete the stack by pressing
[record stack].
PLAYBACK A STACK
Stacks can only be played back on the stack master.
To assign a stack to the stack master, press
[assign]
[page] (optional) (select the page in either the red or blue banks containing the stack)
[F/A] (stack number) (red or blue banks)
[stack flash]
Fade up the stack master to reveal the first step.
INITIATING A CROSSFADE
To crossfade from the current step to the next step, press
[ >] (forward).
While the crossfade is in progress, the > (forward) button flashes for the duration of the IN fade and the < (reverse) button
flashes for the duration of the OUT fade.
STOPPING A CROSSFADE
To stop a crossfade in progress press
[step/stop].
The > (forward) button, < (reverse) button and step/stop buttons all flash.
RESTARTING A STOPPED CROSSFADE
To start a stopped crossfade in the forward direction press [>] (forward).
The crossfade can also be momentarily re-started by holding down [step/stop].
REVERSING A STOPPED CROSSFADE
To start a stopped crossfade in the reverse direction press [<] (reverse).
CROSSFADING TO THE PREVIOUS STEP
To crossfade from the current step to the previous step, press
< (reverse).
You may only crossfade back one step but you may step back to any step.
STEPPING A STACK
To instantly step (snap) a stack in the forward direction hold [step/stop], tap [>] (forward)
To instantly step (snap) a stack in the reverse direction hold [step/stop], tap [<] (reverse)
CLEARING THE STACK MASTER
To clear the stack master press
[remove]
[stack flash]
[yes]