5-18
H92 A35C [Paramete
r write]
0 ~ 1 Copy the parameters from remote loader
and save them into inverter.
0
X
H93 A35D [Paramete
r initialize]
0 ~ 5 This parameter is used to initialize
parameters back to the factory default
value.
0
X
8-32
0 -
1 All parameter groups are
initialized to factory default
value.
2 Only Drive group is initialized.
3 Only Function group 1 is
initialized.
4 Only Function group 2 is
initialized.
5 Only I/O group is initialized.
H94 A35E [Password
register]
0 ~
FFFF
Password for H95-[Parameter lock]. Set
as Hexa value.
0 O 8-33
H95 A35F [Paramete
r lock]
0 ~
FFFF
This parameter is able to lock or unlock
parameters by typing password
registered in H94.
0 O 8-33
UL (Unlock) Parameter change
enable
L (Lock) Parameter change
disable
1)
H91,H92 parameters are displayed when Remote option is installed.
To Next Page
Loading...
Need help?
General
