Chapter 6. Panel Editor
6-88
4) Run Address and Action
(1) Activated when the trigger condition is not ‘Always’, and it specifies the device’s address to execute the block
communication.
(2) Refer to the section ‘6.9.3 Button Tag for details’ to specify the address.
5) Setting Example
(1) The following example represents that M000 device connected to Channel 1 is set On at 09:43:33 on the 1
st
day every
month when No.0 bit of the internal memory S0 of XGT Panel is On.
(2) Assume that reservation function is specified as shown above.
(3) M0000 (Bit device) of PLC is turned on at 9:00:30 on the 1
st
day every month.
To Next Page
Loading...
