Chapter 6. Panel Editor
6-43
• As for XP10BKB/DC, a Latch area can be specified.
• For more information on latch Area, refer to Parameter Setting in the Common Resource menu. S900~S999 is
a system flag area. And refer to the appendix for details about system flags.
• After『S』is selected, click
, then internal device addresses or special flags can be selected as shown
below.
b) Ch 1: specifies the RS-232C channel of the XGT Panel.
Select『Ch 1』, and click
to specify a device and input an address as shown below. (• Click ,
then the following window appears for the user to input an address)
c) Ch 2: sets the devices of the instruments connected to RS-422/485 communication of the XGT Panel. Select 『Ch
2』, and click
to specify a device and input an address as shown above.
(2) Station No.: If Ch 1 or Ch 2 is selected, it will be activated and will set the other Station No. for the correspondent
numeric tag to communicate with. The default value will be the slave Station No. which was set when
the project was created.
To Next Page
Loading...
