Setpoints
- 52 -
BPD17 pH / Redox Monitor
Operating Guide
Clean Recovery
The user can introduce an additional post cleaning
delay before coming back “On-line”, this provides the
sensor a period to stabilise after the cleaning has
finished.
/ – Increase / Decrease Digit
– Select Next Digit
EXIT
– Cancel
– Save Value
Clean Delay
If enabled this causes the clean cycle to wait if any
other control setpoints are active. This is shown by a
clean delayed message on the front screen.
/ – Select Option
EXIT
– Cancel
– Save Selection
Manual Clean
This manually starts a clean cycle.
/ – Select Option
EXIT
– Cancel
– Save Selection
To Next Page
Loading...
