Lucent Technologies SLC-2000 Access System Central Office Terminal - Factory Assembled COT Bays; Frame Mounting Material (1 per COT Frame); Heat Baffles (as required); Ancillary Equipment

To Next Page

To Previous Page

4-2 Issue 4 February 1997

363-208-011

Parts Lists and Kits

Basic SLC-2000 Hardware

Factory Assembled COT Bays

■ J1C265B-1 Front Flush Mounted Shelf Arrangement

■ J1C265C-1 Front Extended Mount Shelf Arrangement

Frame Mounting Material (1 per COT

Frame)

Frame mounting material consists of the basic bay framework, anchoring material,

and miscellaneous hardware to enclose and protect the equipment and cabling

within the bay. The following listings can be used as an ordering guide or as an

installation checklist for material previously ordered. The material that is indicated

as optional is used to enhance the general appearance of the bay or is relevant to

its particular environment.

Refer to the SUPPLEMENTARY INFORMATION chapter of this manual for

detailed information.

Heat Bafﬂes (as required)

■ 845448307- Heat Bafﬂe (1 minimum, 3 maximum)

Ancillary Equipment - Customer Furnished

Ringing Supplies

-48 Volt DC Bulk Power Supply

VF Cross Connect Blocks

Optic Fiber Cross Connect Blocks

Optic Fiber Jumper Cables

Bulk Power and Ringing Cables

DS1 Cross Connect Blocks - optional

Tools and Test Equipment

Lucent Technologies SLC-2000 Access System Central Office Terminal - Factory Assembled COT Bays; Frame Mounting Material (1 per COT Frame); Heat Baffles (as required); Ancillary Equipment - Customer Furnished