Lucent Technologies SLC-2000 Access System Central Office Terminal User Manual

SLC
®
-2000 Access System
COT Assembly Manual
Issue 4 February 1997 1-1
Lucent Technologies
363-208-011
1
General Information
General Information
Installation Activity and Test Sequence
Installation and test operations for SLC

-2000 Central Office Terminal (COT)
Frames are outlined in this text as sequential procedures. For ease of operation,
it is recommended that the format and sequence listed herein be followed.
Common mechanical-type instructions and information are outlined in Chapter 2,
Installation Procedures.
The installation sequence for a SLC -2000 route may begin either at the central
office, remote locations, or simultaneously at any combination of offices,
depending upon the availability and deployment of personnel. The installation
operation is considered complete when all bays are interconnected with the cable
or fiber line facilities, and with the power, ringing and alarm systems
Central Office Terminal
Installation of the COT consists of the assembly, functional wiring, peripheral
cabling, and powering of the 7-foot SLC -2000 COT bays.
Remote Terminal Compatibility
The SLC -2000 COT bay will not work with SLC -2000 RT Release 2.0 bays. RT
Bays must have Release 3.1 and higher software. Installation of the remote
terminal consists of the assembly, functional wiring, peripheral cabling, and
peripheral powering of the 7-foot SLC -2000 RT bays. Also included are the
peripheral equipment, such as the ringing supplies and their associated
interconnections. Refer to Lucent Technologies Practice 363-208--010.

Lucent Technologies SLC-2000 Access System Central Office Terminal Specifications

General

Brand	Lucent Technologies
Model	SLC-2000 Access System Central Office Terminal
Category	Touch terminals
Language	English