Lucent Technologies SLC-2000 Access System Central Office Terminal User Manual

363-208-011, Appendix 3
Tau-tron ngRTH Installation Procedure
Issue 1 November 1998 A3-1
Lucent Technologies
3
Test Head Installation
Remote Test Head Mounting
General
This appendix to the Customer Assembly Manual for COT Frames provides the
procedures to install the Lucent Technologies RTH-7000 or General Signal
Networks Tau-tron 7000 ngRTH
*
remote test head for use with the SLC
®
-2000
Access System.
NOTE:
These test heads are not compatible with the Line Test Fanout (LTF).
NOTE:
Refer to the Lucent Technologies RTH-7000 or the General Signal Net-
works Tau-tron Installation and Maintenance Guide for detailed installation
and troubleshooting instructions for their test head panels.
Test Head Inspection
The test head is shipped with an assortment of associated apparatus.
Step 1: Unpack the test head from its shipping cartons.
Step 2: Verify that the mounting brackets, screws, ground cable, fuse, and
Installation and Maintenance Guide are included.
Step 3: Verify that test head cables are available. The job specification will
provide the list of required cables. See Table 1-1 for the listing of test
head cables.
* ngRTH is a trademark of General Signal Corporation

Lucent Technologies SLC-2000 Access System Central Office Terminal Specifications

General

Brand	Lucent Technologies
Model	SLC-2000 Access System Central Office Terminal
Category	Touch terminals
Language	English