MacDon R113 - Page 5

Section
Summary of Change
Internal Use Only
• Added one electrical cap (MD #134742) for a total
quantity of one.
• Added one electrical harness (MD #281614) for a
total quantity of one.
2.2 Transport Assembly Parts List –
Small Parts Bag, page 8
Created a topic and parts list for the small parts bag
included with the transport assembly, and revised the
parts list as follows:
• Identified fitting MD #136149 as a separate part.
ECN 56030:
• Added footnote: Only used on a pull-type from model
year 2017 or prior.
ECN 57834:
• Added two screws (MD #136313) for a total quantity
of two.
• Added two nuts (MD #030855) for a total quantity
of two.
Added footnotes:
• MD #50101: Only four are used.
• MD #184657: Not used.
ECN 56030
ECN 57834
2.3 Remote Control Parts List, page 10
Added topic and parts list for the remote control and
harness.
Tech Pubs
3.1 Moving Hitch Swing Cylinder, page
13
• Step 1, page 13
Added step for model years 2018 and prior.
ECN 56953
ECN 57017
Product Support
3.1 Moving Hitch Swing Cylinder, page
13
• See the NOTE below Step 6, page
13
Revised the NOTE to read “rod end” (previously was
“clevis end ”):
• The rod end of cylinder will be attached to the
transport casting when the system is primed.
Product Support
3.2.1 Installing Latch Assembly, page
14
• Step 4, page 14
• Step 5, page 14
• Step 6, page 14
Added steps and associated pictures to show new
electrical caps.
ECN 57593
3.2.1 Installing Latch Assembly, page
14
• Step 7, page 14
• Step 8, page 14
• Step 9, page 14
• Step 11, page 15
• Step 12, page 15
Revised steps and/or associated pictures to show new
latch assembly hydraulics.
ECN 56030
214633 iii Revision C