MacDon R113 User Manual (English)

Other manuals for MacDon R113

Operator's Manual294 pages

Unloading And Assembly Instructions234 pages

Quick Guide2 pages

Installation Instructions86 pages

Quick Card User Guide2 pages

Quick Start Guide2 pages

Questions and Answers:

D
Deanna LynchAug 11, 2025
What to do if MacDon R113 cutterbar is plugging?
- S
  Sean WallaceAug 12, 2025
  If the cutterbar is plugging, several factors could be at play. It might be that the blades are dull, bent, or badly worn, in which case you should replace them. Another cause could be a build-up of dirt between the rock guards, so decreasing the mower conditioner angle and increasing flotation might help. In some cases, it may be necessary to carry the mower conditioner slightly with lower skid shoes. Finally, the conditioner drive belt might be slipping, requiring you to adjust the conditioner drive belt tension.
J
John KimAug 22, 2025
Why MacDon Farm Equipment leaves strips of uncut crop on the field?
- A
  Alyssa MossAug 22, 2025
  Leaving strips of uncut crop on the field can happen for a few reasons. Check for bent or dull cutter blades and replace them if needed. A build-up of dirt between the rock guards can also cause this, so decrease the mower conditioner angle and increase flotation. Make sure your ground speed isn't too slow; if it is, increase it. Also, disengage the mower conditioner and stop the engine to remove any foreign object from the cutterbar.
E
evanbishopAug 31, 2025
How to fix ragged or uneven cutting of crop with MacDon Farm Equipment?
- J
  Jordan EricksonAug 31, 2025
  Ragged or uneven cutting of crop could be due to several reasons. If the mower conditioner flotation is too light, causing bouncing, adjust to a heavier float setting. Excessive ground speed can also be a factor, so reduce ground speed. If you're dealing with downed crop, adjust the mower conditioner angle to cut closer to the ground.