215585 167 Revision A
Figure 9.9: Lift Cylinder Lock-Out Valve in Open
Position
4. Open lock-out valve (A) on each lift cylinder by turning the
handle to the open position (in line with hose).
9.1.2 Converting from Field to Transport Mode – Without Transport
Before operating on the road, the hydraulic steering and lift cylinders must be disabled.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator’s seat for any reason.
1. Raise rotary disc pull-type.
2. Move rotary disc pull-type fully to the left, then fully to the right. Repeat this a couple times.
3. Center the rotary disc pull-type.
4. Shut down the engine, and remove the key from the ignition.
Figure 9.10: Steering Lock-Out Valve in Closed
Position
5. Close the steering lock-out valve by turning handle (A) to
the closed position (90° angle to the hose).
TRANSPORTING THE ROTARY DISC PULL-TYPE
To Next Page
Loading...
