MacDon R113 - Chapter 6: Completing Rotary Disc Pull-Type Assembly; Installing Field Wheels

215585 109 Revision A
Chapter 6: Completing Rotary Disc Pull-Type Assembly
6.1 Installing Field Wheels
The pull-type rolls on the field wheels when in the field position. When transport is deployed (if equipped), field wheels are
raised off the road.

$
%
Figure 6.1: Wheel Spindle
1. Remove shipping strap (B) from wheel spindle (A). Repeat
on opposite side.

$
%
Figure 6.2: Wheel Spindle
2. Remove wheel bolts (A) from spindle (B).
CAUTION
When installing wheel, be sure to match countersunk holes
with bolt head profiles. Holes that are not countersunk do NOT
correctly seat the bolts.

$
%
&
Figure 6.3: Installing Wheel Bolts
3. Position wheel (A) on the spindle, install bolts (B), and
partially tighten.
IMPORTANT:
Be sure valve stem (C) points away from the wheel support.
NOTE:
Field wheels must be installed inboard on carrier frame.