MacDon R113 - Page 9

Section
Summary of Change
Internal Use Only
3.4.6 Installing Slow Moving Vehicle
Sign, page 39
• Step 5, page 39
Added “washers” to the step and revised associated
picture.
ECN 57755
3.4.6 Installing Slow Moving Vehicle
Sign, page 39
Removed the last two steps of this procedure because
the speed decal was already attached to the bracket.
Engineering
3.5 Installing Cover, page 40
• Step 1, page 40
Revised picture to clarify step.
Tech Pubs
5.1 Preparing Rotary Disc Pull-Type for
Transport, page 47
Changed the following statement to a WARNING:
• To avoid bodily injury or death from unexpected
startup of machine, always stop engine and remove
key from ignition before leaving operator’s seat for
any reason.
Tech Pubs
5.1 Preparing Rotary Disc Pull-Type for
Transport, page 47
• Step 1, page 47
Added step. Tech Pubs
5.1 Preparing Rotary Disc Pull-Type for
Transport, page 47
• Step 2, page 47
Replaced steps for storing the hitch jack stand with a
reference section at the end of the manual.
Tech Pubs
5.1 Preparing Rotary Disc Pull-Type for
Transport, page 47
• Step 3, page 48
• Step 4, page 48
Flipped the order of these steps.
Product Support
5.2 Transporting with a Tractor, page
49
Removed step for storing the jack stand because this is
completed in the previous section.
Tech Pubs
5.4 Converting from Field to Transport
Mode – With Road-Friendly
Transport
™
, page 51
Added DANGER:
• Stop the power take-off (PTO) before converting the
unit into transport mode. The cutting discs continue
to spin after the drive is turned off.
Changed the following WARNING to a CAUTION:
• To prevent equipment damage, ensure cutterbar
doors are properly closed before converting the
machine from field to transport mode.
Tech Pubs
5.5 Converting from Transport to Field
Mode – With Road-Friendly
Transport
™
, page 56
• Step 1, page 56
Added step.
Changed the following WARNING to a CAUTION:
• To prevent equipment damage, ensure cutterbar
doors are properly closed before converting the
machine from field to transport mode.
Tech Pubs
6.1 Attaching Rotary Disc Pull-Type to
the Tractor, page 61
Added “Attaching Hitch” reference chapters. Tech Pubs
214633 vii Revision C