36 (E)
LT10A / LT11A Series
Note
• When there is a preset value the “reset” command will set
the value to zero. To recall the preset value input the
“recall preset value” command.
• The data set by the commands given in the table will not
be stored by the counter unit.
If the power is turned off the settings must be repeated.
• Provide intervals of at least 5 ms between command
inputs.
However, input the commands after data output is
completed for operations accompanied by data output.
Command
∗P-P
∗MAX
∗MIN
∗REAL
∗RCL
∗RES
∗START
∗P= ¥ ¥ ¥ ¥ ¥ ¥/∗P=?
∗CH= ¥ ¥ ¥ ¥ ¥ ¥/∗CH=?
∗CL= ¥ ¥ ¥ ¥ ¥ ¥/∗CL=?
∗r
R
KEYON
KEYOFF
∗PAUON
∗PAUOFF
∗LCHON
∗LCHOFF
VER=?
Operation
Switch to peak-to-peak value mode.
Switch to maximum value mode.
Switch to minimum value mode.
Switch to current value mode.
Recall the preset value.
Reset.
Start.
Set/read preset value.
Set/read comparator upper limit.
Set/read comparator lower limit.
Request for output for one channel.
Request for outputs for 2 channels.
Allow use of front panel key.
Prohibit use of front panel key.
Stop peak value update
Release peak value update stop
Latch the current value.
Release the current value latch
Read software version
8-6. Commands
1. Command table (Converted to ASCII code)
∗ : For the 1 channel model or the 2 channel model A
channel use “A”, for the 2 channel model B channel
use “B”.
¥ : Value to be set. (Example: 12.345)
To Next Page
Loading...
