(E) 45
LT10A / LT11A Series
11.
Troubleshooting
When the unit does not work properly, check the following before calling Magnescale Co., Ltd. Representative for service
• Turn off the power and turn it on 1 minute later.
• Check the connection and continuity of the power line.
• Check for the proper range of power voltage.
• Reset the unit after moving the measuring unit at least 1 mm.
• Has the measuring unit’s cable been disconnected?
• Has the maximum response speed for the measuring unit been exceeded?
• Perform resetting operation.
• First carry out the reset procedure.
• Was the measuring unit exchanged with the power on?
• Is the measuring unit’s connector locked?
• Is the measuring unit’s cable disconnected?
• Connect a correctly functioning measuring unit and reset.
• Is the preset value too large (Overflow)?
Fifth digit is “F”
Channel display is
(Alarm)
is displayed (Alarm)
The power cannot
be turned on.
Value is flashing
To Next Page
