Magnescale LT10A-105 - 9 Alarm Display;Output

40 (E)
LT10A / LT11A Series
RS-232C
(Note)
Output
9. Alarm display/output
I/O connectors
Item
LCD
Fifth digit is F
Value for axis is flashing.
Solution
Cause
(Note) When the output data format is the initial setting . See P38, 39 for other formats.
Note
If the alarm is again displayed/output after solving the problem
Has the measuring unit or its spindle received some strong shock?
Try replacing with the measuring unit used for the other channel.
Reset
Fix problem and
reset.
Reset
Fix problem and
reset.
Limit input to 5 digits
and reset.
Move the measuring
unit at least 1 mm
and reset.
The measuring unit was
exchanged with the power on.
Measuring unit is not
connected or connection
has been cut
The measuring unit’s
spindle exceeded the
maximum response
speed.
Abnormality in measuring
unit’s output signal or
connection has been cut.
Value exceeded 5 digits.
Initialization is required to
calibrate the new pairing of
both device and measuring
unit.
∗E
C
R
L
F output.
(∗ is A or B.)
∗>FX.XXX
C
R
L
F output.
(∗ is A or B, > is a plus
sign
or a minus sign, X
is a numeral.)
: (“+” or space)
∗E
C
R
L
F output.
(∗ is A or B.)
Alarm terminal is
“H”
True logic: fifth
digits are all “H”.
False logic: fifth
digits are all “L”.
Alarm terminal is
“H”
All “H”
—
All “H”
Measuring unit is
not connected or
connection has
been cut.
Speed over
Signal disorder or
connection cut
Overflow
Initialization is
required.
BCD