(E) 1
LT10A / LT11A Series
1-1. General precautions
When using Magnescale Co., Ltd.
products, observe the
following general precautions along with those given
specifically in this manual to ensure proper use of the
products.
• Before and during operations, be sure to check that our
products function properly.
• Provide adequate safety measures to prevent damage in
case our products should develop a malfunction.
• Use outside indicated specifications or purposes and
modification of our products will void any warranty of the
functions and performance as specified for our products.
• When using our products in combination with other
equipment, the functions and performance as noted in
this manual may not be attained, depending upon the
operating environmental conditions. Make a thorough
study of the compatibility in advance.
• Design and specifications are subject to change without
notice.
1. Note to users
1-2. Handling instructions
• Do not open the cover of this device or put your hand
inside. Otherwise the internal circuit may be broken by
static electricity.
• To prevent malfunctions caused by static electricity,
always turn off the power when touching other parts than
the key switches.
• Do not route the connecting cable through the same duct
as the machine power line.
• To prevent misoperation of surrounding equipment due
to noise emitted from this counter unit and vice versa,
connect the power cable in a twisted manner when
supplying DC power.
• When providing DC power, be sure to use within the
specified voltage range.
• Absolutely do not connect an AC power supply to the I/O
connector. Doing so may damage the internal circuits.
• Do not use connection prohibited I/O connector pins as
relay pins.
• When connecting the BCD connector, be sure to wire the
connector correctly.
Failure to do so may damage the internal circuits.
To Next Page
Loading...
