Mahr GmbH, Digimar 817 CLT
11
2.3 Measuring slide
The measuring slide is in the column of the
height measuring instrument and holds the
carriers for the measuring anvils.
The measuring slide features a positioning
handle, which can be used to manually move
the measuring slide in a vertical direction.
1
2
3
2 Positioning handle
3 Standard holder with measuring anvil
The overall height of the column depends on
the size of the chosen measuring instrument:
•
Height 688 mm (measuring range 350 mm)
•
Height 938 mm (measuring range 600 mm)
•
Height 1338 mm (measuring range 1000 mm)
2.4 Carrier for measuring anvils
The carrier for the measuring anvils can be
used to hold different anvils. The instrument
comes with standard holder 817 h1 and
measuring probe K5/51.
Other carriers and measuring anvils are
available as accessories.
2.5 Quick measurement function keys
The quick measurement function keys can be
used to start a measurement quickly without
having to select it in the user interface of the
Digimar software.
The quick measurement keys include a toggle
key, which can be used to toggle between
"plane" and "bore" measurements.
The quick measurement function keys are
located on the base of the height measuring
instrument.
Starts a measurement in the positive
direction by moving the probe up to
contact the workpiece from below.
Starts a measurement in the
negative direction by moving
the probe down to contact the
workpiece from above.
Toggles the measurement type:
"Plane" for a single point
measurement
"Bore" measurement for a
double point measurement
The status bar of the user interface
displays the icon of the active
measurement.
To Next Page
Loading...
Need help?
General
