Mahr GmbH, Digimar 817 CLT
1
Dear customer,
Thank you for choosing a product by Mahr
GmbH. We kindly request that you follow the
instructions below to ensure the long-term
precision of your instrument.
We operate a policy of continuous improvement
and are constantly developing our products.
Therefore, it is possible that there may be slight
differences between the text and illustrations
in this document and the instrument in your
possession, especially with regard to type
designations. We reserve the right to make
changes to the design and scope of supply,
the right to undertake further technical
developments, and all rights relating to
translation of this documentation.
© by Mahr GmbH
The following symbols are used in this
quick guide:
General information.
Important information. Failure to
follow instructions marked with this
symbol may cause inaccurate results
and damage equipment.
Warning. Risk of injury or death.
Mustbe observed!
The Bluetooth
®
brand name is the property of Bluetooth
SIG, Inc, which has licensed the use of these brands by
Mahr GmbH. Other brand names and trade names are the
property of their respective owners.
Permitted uses
The Digimar 817 CLT height measuring
instrument may only be used to measure
lengths, distances, and diameters.
The Digimar 817 CLT height measuring
instrument can be used both close to
production and in measuring rooms.
Do not modify the instrument. This may
create additional hazards against which the
safety mechanisms cannot offer adequate
protection.
Any use not in accordance with the
"Permitted Uses" or any other use will
be considered inappropriate and will
result in a voided warranty and the
manufacturer's exclusion from liability.
Reasonably foreseeable misuse
Any incidental maintenance work may
only be carried out by skilled, trained
staff as directed by the operating
company.
Work on any parts carrying live voltage
must only be carried out once the
power supply to the device has been
disconnected and any potential
residual voltage has been safely
discharged.
Safety mechanisms on the device
must not be disassembled or
bypassed.
Only original probe systems, probe
arm units and other accessories
produced by the manufacturer may
be used.
To Next Page
Loading...
Need help?
General
