Mahr Digimar 817 CLT - Page 18

Mahr GmbH, Digimar 817 CLT
16
Basic measuring functions
Contacting from below
Contacting from above
Bore
Shaft
Bore top
Bore bottom
Shaft bottom
Shaft top
Groove
Ledge
Bore center
Min-Max
Cone measurement
Perpendicularity measurement
Enable 2D mode
Enable measuring program mode
Output measuring results as
measuring record file in PDF format
Output measuring results as Text file
Calculation functions
Distance calculation
Symmetry calculation
Set zero point workpiece
Automatic distance calculation
Automatic chain measurement
Other buttons for functions
If other information is possible for any of the
functions, the following buttons are displayed
in the function key bar depending on the
function:
Move measuring probe upwards and
contact
Move measuring probe downwards
and contact
Stop measurement and calculation
of measuring results
Pause measurement
Set measuring plate as reference for
the measuring results
Calculate the relative result values for
"Min-Max function"
Calculate absolute result values for
"Min-Max function"
Set X-value and Z-value to zero, e.g.
in "perpendicularity measurement"