Mahr Digimar 817 CLT - Page 20

Mahr GmbH, Digimar 817 CLT
18
Edit measuring programs
The buttons below add the relevant function
as a measuring step:
"Contacting from below" measuring
function
"Contacting from above" measuring
function
"Bore" measuring function
"Shaft" measuring function
"Bore top" measuring function
"Bore bottom" measuring function
"Shaft bottom" measuring function
"Shaft top" measuring function
"Groove" measuring function
"Ledge" measuring function
"Bore center" measuring function
Function
"Base zero point measuring plate"
"Distance calculation" calculation
function
"Symmetry calculation" calculation
function
"Delay" function
"Set zero point workpiece" calculation
function
Running measuring programs
Starts running the measuring
program
Performs the next measuring step in
the measuring program
Stops the measuring program
Pauses the measuring program
Skips to the previous measuring step
All of the functions are explained in
detail in the online help of the Digimar
software.
i