15
16
17
18
Removing and fitting camshaft bearing bushes
109
Fig. 15
Place the press-in plate Å with fitted bearing bush
on the shaft.
The press-in plate is fixed in place by the groove
so that the oil holes line up after pressing in.
Fig. 16
Here, insert the guide bush  with the small diam-
eter in the bearing hole and let the spring-loaded
balls lock into the oil holes.
The groove of the shaft must then face upwards.
Apply the press-in plate Å with fitted bearing bush.
Fig. 17
Use a soft hammer (plastic or copper) to drive
camshaft bearing bush 2 in as far as it will go.
Press in camshaft bearing bushes, bearings 3
and 4
Fig. 18
Arrangement of special tools:
À Shaft with groove and fixed stop
 Double-sided guide bush
à Press-out plate as additional guide
Å Press-in plate
6
3 6
1 3 4 6
To Next Page
Loading...