1
2
3
4
Replacing cylinder liners
125
Removing cylinder liners
Note:
Observe oversizes for cylinder liner out-
side diameters and collar heights (see
“Service data”).
D Remove cylinder head, see page 78
D Remove piston, see page 118
Fig. 1
Special tool for removing the cylinder liners.
Fig. 2
Mark the cylinder liner position relative to the en-
gine so that it can be reinstalled if reused.
Insert the cylinder liner extractor apparatus into the
cylinder liner, taking care not to damage the oil
spray nozzle.
Fig. 3
Fit the support on the extractor spindle and screw
on the nut.
Hold the extractor spindle in place and extract the
cylinder liner by turning the nut.
Fig. 4
Remove the extractor apparatus and take out the
cylinder liner.
To Next Page
Loading...