5
6
7
8
Removing and installing the cylinder head
79
Installing cylinder head
Fig. 5
Before fitting, clean and blow out the threaded
holes in the crankcase. Clean the sealing surfaces
on the cylinder head and on the crankcase.
Lay the new cylinder head seal in place, ensuring
that the hole patterns match up, and place the cyl-
inder head on top.
Each cylinder head is fixed in position with 2 fitting
sleeves.
Fig. 6
Check the tappet push rod for deformation.
When inserting the tappet push rods, ensure that
they fit in the socket of the valve tappet.
Insert the valve bridges with the cut−through sides
Á facing the push rods.
Fig. 7
Apply a thin bead of “Loctite 5900” sealing com-
pound to seal the rocker arm bearing housing.
Caution:
The bore hole (À in Fig. 6) must be kept
clear for the oil supply!
Fig. 8
Fit the rocker arm bearing housing, inserting the
rocker arm ball pins into the tappet ball sockets.
1
2
To Next Page
Loading...