Manitou MHT 10225 - B - Reinserting the Engine Cooling Water Pump

(25/11/2011)10-07-M184EN
10
16 ENGINE REFIT
B - REINSERTING THE ENGINE COOLING WATER PUMP
Replace the gaskets with new ones, re t the pump (Ref. 1) and
the thermostatic valve (Rif. 2) on the engine by means of the
7 screws (Ref. 3), on which Loctite threadlock must be applied;
use a 25 Nm tightening torque.
Re t the thermostatic valve (Ref. 2) on the pump by means of
the screws (Ref. 4 and 5) on which Loctite threadlock must be
applied; use a 25Nm tightening torque.
Reconnect the temperature sensor (Ref. 6) on the thermostatic
valve (Ref. 2).
2
4
2
5
2
3
3 3
3
3
1
3
3
6