Manitou MI 20 D K ST5 S1 - Operating the Horn on the Mini-Levers; Operating the Rotating Beacon; Operating the Heater; Driving the Machine

54 647852EN-USM1(B-12/2021)
MACHINE OPERATION
• Press the red button on the driving seat access
handle.
In both cases, the horn will sound.
3.2.5 OPERATING THE HORN ON
THE MINI-LEVERS
• Press on the button on the side of the mini-lever
armrest.
The horn will sound.
3.2.6 OPERATING THE ROTATING
BEACON
• Press on the rotating beacon switch to turn the light
on and off.
3.2.7 OPERATING THE HEATER
• Press on the heater switch to turn the heating on
and off.
You may choose between two fan
speeds.
3.2.8 DRIVING THE MACHINE
3.2.8.1 Operating the gear selector
NOTICE
Risk of transmission damage
Do not accelerate while changing gears.
Change gears at speeds below 2km/h.
The gear selector will not work unless the OPS system
prerequisites are met.
Figure 26: Gear selector
• Neutral position
1. Stop the machine.
2. Move the lever to position (1).
• Forward drive position
1. Stop the machine.
2. Move the lever to position (2).
• Reverse drive position
1. Stop the machine.
2. Move the lever to position (3).
The reversing lights are on and the audible
reverse warning is on.
3.2.1 Operating the machine with the operator
presence system, page 53
3.2.8.2 Operating the gear selector on the
mini-levers
NOTICE
Risk of transmission damage
Do not accelerate while changing gears.
Change gears at speeds below 2km/h.
The gear selector will not work unless the OPS system
prerequisites are met.
2
3
1
3.