72 647852EN-USM1(B-12/2021)
MAINTENANCE
4.7. 10 HOURS OF SERVICE OR
DAILY MAINTENANCE
4.7.1 CHECK ENGINE OIL LEVEL
Place the lift truck on level ground with the
engine stopped, and let the oil settle in the
sump.
1. Raise the engine cover.
2. Remove the dipstick (1).
3. Wipe the dipstick and check the correct level
between the MINI and MAXI marks.
4. If necessary, add oil by the filler port (2).
5. Visually check that there is no leakage or seepage
of oil in the engine.
4.7.2 CHECK COOLING LIQUID
LEVEL
DANGER
To avoid any risk of spraying or scalding, wait until the
engine has cooled down before removing the cooling system
filler plug. If the cooling fluid is very hot, add only hot
cooling fluid (80°C). In an emergency, you can use water as
a coolant. In such a case, the cooling system fluid should be
changed as soon as possible.
Place the lift truck on level ground with the
engine stopped, and allow the engine to cool.
1. Raise the engine cover.
2. The fluid must be at the MAX level on the expansion
tank (1).
3. If necessary, add cooling fluidthrough the filler port
(2).
4. Check visually that there is no leakage in the
radiator and pipes.
When the expansion tank is empty,
check the level in the radiator before
filling the expansion tank.
5. Slowly turn the cap of the radiator (3) up to the
safety stop.
6. Allow the pressure and the steam to escape.
7. Press down and turn the cap so as to release it.
8. Add cooling fluid through the filler port.
9. Lubricate slightly the filler neck in order to facilitate
the setting and the removal of the radiator cap.
4.7.3 CHECK FUEL LEVEL
DANGER
Never smoke or approach with a flame during filling
operations or when the tank is open. Never refill while
engine is running.
4.
To Next Page
Loading...
