18 647852EN-USM1(B-12/2021)
SAFETY
1.5.2 PREPARING THE LIFT TRUCK
• Clean the lift truck thoroughly.
• Check and repair any fuel, oil, water or air leaks.
• Replace or repair any worn or damaged parts.
• Wash the painted surfaces of the lift truck in clear
and cold water and wipe them.
• Touch up the paint work if necessary.
• Stop the lift truck.
• Make sure the mast cylinder rods are all in the
retracted position.
• Release the pressure in the hydraulic circuits.
1.5.3 PROTECTING THE ENGINE
• Contact your dealer to obtain the procedure for
protecting the inside of the engine (use of protection
product).
• Fill the tank with fuel .
• Drain and replace the coolant .
• Leave the engine running at idling speed for a few
minutes, then switch off.
• Replace the engine oil and oil filter .
• Run the engine for a short time so that the oil and
cooling liquid circulate inside.
• Disconnect the battery and store it in a safe place
away from the cold after charging it to a maximum
• Block the outlet with waterproof adhesive tape.
• Remove the drive belts and store them in a safe
place
• Disconnect the engine cut-off solenoid on the
injection pump and carefully insulate the
connection.
1.5.4 PROTECTING THE LIFT TRUCK
• Set the lift truck on axle stands so that the tyres are
off the ground.
• Release the parking brake (depending on the model
of lift truck).
• Protect cylinder rods which will not be retracted,
from corrosion.
• Wrap the tyres.
If the lift truck is to be stored outdoors,
cover it with a waterproof tarpaulin.
1.5.5 BRINGING THE LIFT TRUCK
BACK INTO SERVICE
WARNING
Ensure the area is sufficiently ventilated before starting the
lift truck.
• Remove the waterproof adhesive tape from all the
holes.
• Refit and reconnect the battery.
• Remove the protection from the cylinder rods.
• Perform the daily maintenance operations .
• Put the handbrake on and remove the axle stands.
• Drain and clean the fuel tank .
• Fill the fuel tank with clean diesel filtered through
the filler port.
• Replace the fuel filter .
• Replace the fuel pre-filter (depending on the model
of lift truck)
• Drain and rinse the DEF tank (depending on the
model of lift truck)
• Top up, slowly fill the tank with new "DEF" (Diesel
Exhaust Fluid) up to the bottom of the filler neck
(depending on the model of lift truck)
• Refit the drive belts and adjust the tension .
• Turn the engine over with the starter, to allow the oil
pressure to rise.
• Reconnect the engine cut-off solenoid.
• Lubricate the lift truck completely .
• Start up the lift truck, following the safety
instructions and regulations.
• Carry out all the boom hydraulic movements,
concentrating on the ends of travel for each
cylinder.
1.6. LIFT TRUCK DISPOSAL
1.6.1 RECYCLING OF MATERIALS
Metals
• Metals are 100 % recoverable and recyclable.
Plastics
• Plastic parts are identified with a marking in
accordance with current regulations.
1.
To Next Page
Loading...
Need help?
General