MAINTENANCE
4.
83647852EN-USM1(B-12/2021)
4.2.Remove filler plug (4) in order to ensure that the
oil is drained properly.
Dispose of the drain oil in an
ecological manner.
5. Cleaning the metal oil filter
5.1.Remove the plate (5) and set aside the O-ring
joint (6) and the thrust washers (7).
5.2.Allow the rest of the oil to drain away.
5.3.Clean the metal filter (8) with a compressed air
jet.
5.4.Clean the magnetic part (9).
5.5.Reassemble the unit.
6. Filling up the oil
6.1.Refit and tighten drain plug (3).
6.2.Fill up with oil through filler port (10).
For this operation, we recommend
you use a funnel fitted with a hose.
6.3.Wait a few minutes to allow the oil to flow into the
sump.
6.4.Start the engine and let it run for a few minutes.
6.5.Check for any possible leaks from the oil filter
drain plug.
6.6.Stop the engine, wait a few minutes and check
the level between the MAX and MIN marks on
dipstick (11).
6.7.Top up the level if necessary.
4.10.5 REPLACE HYDRAULIC OIL
NOTICE
Before any intervention, thoroughly clean the area
surrounding the drain plugs and the plate on the hydraulic
tank.
Place the lift truck on level ground with the
engine stopped, and the mast lowered as far as
possible.
1. Draining the oil
To Next Page
Loading...
