86 647852EN-USM1(B-12/2021)
MAINTENANCE
4.10.7 CHECK SEAT BELT
DANGER
If the seat belt is defective (fixing, locking, cuts, tears, etc.),
the lift truck must not be used. Repair or replace the seat
belt immediately.
1. Check fixing of the anchoring points on the seat.
2. Check cleanness of the strap and the locking
mechanism.
3. Check triggering of the locking mechanism.
4. Check condition of the strap (cuts, curled edges).
5. Check the correct winding of the belt. (Reeled seat
belt with two anchoring points)
6. Check condition of the reel guards. (Reeled seat
belt with two anchoring points)
7. Check roller locking mechanism when the strap is
given a sharp tug. (Reeled seat belt with two
anchoring points)
After an accident, replace the seat belt.
4.11. 2000 HOURS OF SERVICE
OR 2 YEARS
4.11.1 REPLACE COOLING FLUID
These operations are to be carried out if
necessary or every two years at the beginning of
winter. Place the lift truck on level ground with
the engine stopped and cold.
1. Draining the liquid
1.1.Raise the engine cover.
1.2.Open radiator drain valve (1).
1.3.Undo engine block drain plug.
1.4.Remove expansion tank filling plug (2) and empty
the tank.
1.5.Remove radiator filler cap (3).
1.6.Let the cooling circuit drain entirely while
ensuring that the ports do not get clogged.
1.7.Check the condition of the hoses as well as the
fastening devices and change the hoses if
necessary.
1.8.Rinse the circuit with clean water and use a
cleaning agent if necessary.
2. Filling the liquid
2.1.Close radiator drain valve (1).
2.2.Retighten engine block drain plug (2).
2.3.Slowly fill the circuit with the cooling fluid through
the filler port .
2.4.Fill the expansion tank to the maximum level
through the filler port.
2.5.Run the engine at idle for a few minutes.
2.6.Check for any possible leaks.
2.7.Check the level and refill if necessary.
2.8.Refit expansion tank filler plug (3).
4.
To Next Page
Loading...
