60 647852EN-USM1(B-12/2021)
MACHINE OPERATION
• Move the mini-lever (3) forwards to move sideways
to the left
Attachment
• Move the mini-lever (3) forwards or backwards
Additional accessory
• Move the mini-lever (4) forwards or backwards
3.2.1 Operating the machine with the operator
presence system, page 53
3.2.9.4 Adjusting the fork spacing
The machine must be unloaded
1. Pull up the adjusting knob and turn it 180 degrees to
unlock the fork
Figure 31: Fork spacing adjustment
2. Slide the forks to the left or the right to adjust them
3. Turn the adjusting knob 180 degrees and push it
down to lock the fork
3.3. MANAGEMENT OF THE
POLLUTION CONTROL
SYSTEM
3.3.1 DEACTIVATING THE EXHAUST
REGENERATION
NOTICE
Risk of engine damage
Only inhibit the exhaust regeneration in impossible
regeneration situations (for example : indoor use).
Only reactivate the exhaust regeneration when the
conditions are appropriate.
Inhibiting the exhaust regeneration for too long will lead to
an increased clogging of the DPF.
1. Enter the “Setting page” on the display screen
2. Enter the “Emissions” setting page
3. Press on “Inhibit” button to turn off the exhaust
regeneration function
3.3.2 REACTIVATING THE EXHAUST
REGENERATION
1. Enter the “Setting page” on the display screen
2. Enter the “Emissions” setting page
3. Press on “Cancel inhibit” button to turn back on
the exhaust regeneration function
3.3.3 STARTING THE PARKED
REGENERATION
DANGER
Risk of suffocation
Park the machine in a safe and adequately ventilated place
NOTICE
Risk of engine damage
Do not stop the exhaust regeneration unless it’s absolutely
necessary
Do not use any machine functions while the exhaust
regeneration is in progress
3.
To Next Page
Loading...
Need help?
General
