94 647852EN-USM1(B-12/2021)
REFERENCES & ATTACHMENTS
5.3. ATTACHMENT
SPECIFICATIONS
5.3.1 INTRODUCTION
Your lift truck must be used with interchangeable
equipment. These items are called: ATTACHMENTS. A
wide range of attachments, specially designed and
perfectly suitable for your lift truck is available and
guaranteed by MANITOU.
NOTICE
Only attachments approved by MANITOU are to be used on
our lift trucks The manufacturer’s liability will be denied in
case of modification or of attachment adaptation carried out
without his knowing it.
The attachments are delivered with a load chart
concerning your lift truck. The operator’s manual and
the load chart should be kept in the places provided in
the lift truck. For standard attachments, their use is
governed by the instructions contained on this notice.
WARNING
Maximum loads are defined by the capacity of a lift truck
taking account of the attachment’s mass and centre of
gravity. In the event of the attachment having less capacity
than the lift truck, never exceed this limit. All attachments
with a suspended load (winch, crane jib, crane jib with
winch, hook, etc.) MUST be used with a lift truck equipped
with a hydraulic movement cut-out device. In this case, the
movement cut-out must be switched on and the transverse
attitude perfectly horizontal.
Some particular uses require the adaptation of the
attachment which is not provided in the price-listed
options. Optional solutions exist, consult your dealer.
5.3.2 TECHNICAL SPECIFICATIONS
OF ATTACHMENTS
• *: Double Mast With All-Round Vision (DVT)
• **: Double Mast With Total Free-Acting Lift (DLL)
• ***: Triple Mast With Free-Acting Lift (TLL)
Standardized side-shift carriage for MI 20/
25 D K ST5 S1
Table 71. Standardized side-shift carriage for MI 20/25 D K ST5 S1
HC 20/25 * HC 20/25 ** HC 20/25 ***
Part Number
- - -
Rated capacity 2500 kg 2500 kg 2500 kg
5.
To Next Page
Loading...
