MAINTENANCE
4.
79647852EN-USM1(B-12/2021)
1.2.Steering rod lubricators (4 lubricators).
1.3.Rear axle oscillation pin lubricators (2
lubricators).
4.9. 500 HOURS OF SERVICE
OR 6 MONTHS
4.9.1 REPLACE DRY AIR FILTER
CARTRIDGE
WARNING
Change the cartridge in a clean location, with the engine
stopped. Never operate the lift truck with the air filter
removed or damaged.
Pre-filtration cartridges are available for use in a
heavily dust laden atmospheres. The cartridge
checking and cleaning interval must also be
reduced (to 250 hours in a heavily laden dust
atmosphere and with pre-filtration).
1. Raise the engine cover.
2. Release the bolts (1) and remove cover (2).
3. Gently remove the cartridge (3), taking care to avoid
spilling the dust.
4. Leave the safety cartridge in place.
5. The following parts must be cleaned with a damp,
clean lint-free cloth.
5.1.The inside of the filter and cover.
5.2.The inside of the filter inlet hose.
5.3.The gasket surfaces in the filter and in the cover.
6. Check pipes and connections between the air filter
and the engine.
7. Before mounting check the state of the new
cartridge.
8. Introduce the cartridge into the filter axis and push it
in, pressing the edges and not the middle.
9. Refit the cover (2).
4.9.2 REPLACE ENGINE OIL
Place the lift truck on level ground, let the engine
run at idle for a few minutes, then stop the
engine.
To Next Page
Loading...
