Manitou MT 733 EASY 75D ST5 S1 User Manual

REPLACE Front axle differential oil
REPLACE Rear axle differential oil
Place the lift truck on level ground with the engine stopped and the still warm differential
oil.
t
IMPORTANT
t
Dispose of the drain oil in an ecological manner.
- Place a container under drain plugs1 and unscrew them.
- Remove level plug2 and filling plug3 to ensure that the oil is drained properly.
- Refit and tighten the drain plugs1 (tightening torque34-49 N.m).
- Fill up with oil (eLUBRICANTS AND FUEL) through filler hole3.
- The level is correct when the oil level is flush with the edge of opening2.
- Check for any possible leaks at the drain plugs.
- Refit and tighten level plug2 (tightening torque34-49 N.m) and filling plug3 (tightening torque34-49 N.m).
- Repeat this operation for the rear axle differential.
REPLACE Hydraulic return oil filter cartridge
Stop the engine and release the pressure from the systems by operating the hydraulic
controls.
t
IMPORTANT
t
Thoroughly clean the outside of the filter and its surroundings before any operation to prevent any risk of polluting
the hydraulic system.
Tighten the body of the filter by hand pressure only and lock the body of the filter in place by a quarter turn.
- Place a container under hydraulic return oil filter1.
- Unscrew the body of the filter.
- Remove the hydraulic return oil filter cartridge and replace with a new one (eFILTER
CARTRIDGES AND BELTS).
- Make sure that the cartridge is correctly positioned and refit the body of the filter.
- Wait a few moments while the oil flows into the container.
1
REPLACE Gear box oil filter
t
IMPORTANT
t
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (e1-INSTRUCTIONS
AND SAFETY RECOMMENDATIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
Tighten the gear box oil filter by hand pressure only and lock the filter in place by a quarter turn.
- Remove the cover plate1.
NOTE: When removing cover plates and hatches, clean the surrounding area and remove
any accumulations of flammable materials.
- Unscrew and discard gear box oil filter2.
- Carefully clean the filter head with a clean, lint-free cloth.
- Lightly oil the new seal and fit it to the filter.
- Fill up the new gear box oil filter (
e FILTER CARTRIDGES AND BELTS) with oil
(eLUBRICANTS AND FUEL).
- Refit the filter, making sure that the seal is correctly positioned and tightened.
- Refit cover plate1.
3 - 26
2
3
2
1
1
1
1
647776 (28/02/2020) MT 733/933/1033 EASY 75D ST5 S1
www.duma-rent.com

Manitou MT 733 EASY 75D ST5 S1 Specifications

General

Brand	Manitou
Model	MT 733 EASY 75D ST5 S1
Category	Trucks
Language	English