PICKING UP THE ATTACHMENTS
1 - ATTACHMENT WITHOUT HYDRAULICS AND HAND LOCKING DEVICE
FITTING AN ATTACHMENT
- Ensure that the attachment is in a position facilitating the locking to the carriage. If
it is not correctly oriented, take the necessary precautions in order to move it safely.
- Check that the locking pin is in position in the bracket (Fig. A).
- Place the lift truck with the boom lowered in front of and parallel to the attachment,
and tilt the carriage forwards (Fig. B).
- Bring the carriage under the locking tube of the attachment, slightly raise the boom,
tilt the carriage backwards in order to position the attachment (Fig. C).
- Lift the attachment off the ground to facilitate locking.
MANUAL LOCKING
- Take the locking pin on the bracket (Fig. A) and lock the attachment (Fig. D).
Do not forget to fit the cotter pin.
MANUAL UNLOCKING
- Proceed in the reverse order to MANUAL LOCKING, taking care to refit the locking
pin in the bracket (Fig. A).
REMOVING THE ATTACHMENT
- Proceed in the reverse order to FITTING AN ATTACHMENT, taking care to store
the attachment flat on the ground and in the closed position.
4 - 4
A
B
C
D
To Next Page
Loading...
