9-9
GRT8100 SERVICE MANUAL LUBRICATION
Published 3/26/2018, Control # 596-05
Table 9-4Approved Lubricant Reference Table
Ref. Approved Lubricant
Lube Specification
Down To -9˚C (15˚F)
Lube Specification
Down To TO -29˚C
(-20˚F)
Lube Specification
Down To -40˚C
(-40˚F)
A
Extreme Pressure Multipurpose Grease 6829003477 6829104275 6829104275
B
Gear Lube (GL-5) 6829014058 6829014058 6829014058
C
Fully Formulated Anti-Freeze Coolant 6829101130 6829101130 6829104212
D
Liquid Coolant Conditioner 6829012858 6829012858 6829012858
E
Tractor Hydraulic Fluid 6829006444 6829101559 6829101559
F
Engine Oil SAE 6829104182 (15W-40) 80056036 (0W-40) 80056036 (0W-40)
G
Open Gear Lube 6829102971 6829102971 6829102971
H
Extreme Pressure Gear Lube 6829100213 6829103636 6829103636
J
Hydraulic Oil 6829006444 6829006993 6829006993
K
Diesel Exhaust Fluid (DEF) 80019225 80019225 80019225
L
Extreme Pressure Multipurpose Grease 6829015304 6829104275 6829104275
Item
Lube Point
Description
Figure
No.
Approved
Lubricant
Lube
Capacity
Lube Interval Application
Drive Train
1 Air Cleaner Filter Figure 9-1 --- ---
• Replace filter element
when indicator shows
red.
2 Fuel Filter Figure 9-1 --- ---
Change filter every 500
hours or 6 months.
Fuel filter is located
on inside right hand
side of frame beside
engine.
3
Engine
Crankcase
Figure 9-1
F
Tier 3 and
Tier 4
20 L
(21 qt)
• Check level every 10
hours or daily
• Drain, fill and replace
filter every: 500 hours
(0-500 ppm sulfur fuel);
400 hours
(500-5000 ppm sulfur
fuel); 250 hours
(>5000 ppm sulfur fuel)
• Through fill cap to
FULL mark on
dipstick
• Refer to Item 6.
4
Engine Cooling
System and SCA
Levels
Figure 9-1 C, D
52.7 L
40 qt
• Check coolant level
every 10 hours or daily
• Check SCA levels
every 500 hours
• Check coolant for
contamination every
1000 hours
• Check level in
sight glass at
rear of crane.
• Superstructure
must be rotated
to access filler
on top of carrier.
To Next Page
Loading...
Need help?
General
