Model WT3-201M Motorized Wire Crimp Pull Tester User’s Guide
Displayed at the start of calibration if a disallowed unit is selected.
Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.
The calibration weight does not match the set value.
The entered calibration point is too close to the previous point.
Load too close
to previous.
Please try again.
Load too low.
Please try again.
Load not stable.
Please try again.
Units must be lbF.
Please try again
Press ENTER.
To Next Page
Loading...
Need help?
General
