Model WT3-201M Motorized Wire Crimp Pull Tester User’s Guide
3.4 Connecting power
Plug one end of the power cord into its receptacle at the rear of the tester and the other end into a wall
outlet with local earth ground (3-prong connector).
Before turning on power, the following safety checks and procedures should be performed:
1. Never operate the tester if there is any visible damage to the power cord or the tester
itself. The WT3-201M is powered by 100-240VAC. Any contact with this high voltage can cause
serious injury or even death.
2. Ensure that the tester is kept away from water or any electrically conductive liquids at all
times.
3. Make sure the electrical outlet powering the tester has local earth ground (3-prong
connector).
4. The tester should be serviced by a trained technician only. Power must be disconnected
before disassembly.
5. Never use a detachable mains supply cord with inadequate ratings.
After the above safety checks and procedures have been performed, the tester may be powered on and
is ready for operation.
To Next Page
Loading...
Need help?
General
