Masimo LiDCO - Cleaning and Service Warnings and Cautions; Compliance Information Warnings and Cautions

Masimo LiDCO Safety Information, Warnings and Cautions
www.masimo.com 11 Masimo
Cleaning and Service Warnings and Cautions
WARNING: Do not attempt to remanufacture, recondition, or recycle Masimo LiDCO as these processes
may damage the electrical components, potentially leading to patient harm.
WARNING: Service of the module should be done by qualified personnel only.
CAUTION: Only perform maintenance procedures specifically described in the manual. Otherwise, return
the module for servicing.
CAUTION: Do not allow liquids to enter the interior of the device.
CAUTION: Do not use petroleum-based or acetone solutions, or other harsh solvents, to clean the
module. These substances affect the device’s materials and instrument failure can result.
CAUTION: Do not submerge the module in any cleaning solution or attempt to sterilize by autoclave,
irradiation, steam, gas, ethylene oxide or any other method. This will seriously damage the device.
CAUTION: Do not use undiluted bleach (5% - 5.25% sodium hypochlorite) or any cleaning solution other
than those recommended here because permanent damage to the module may occur.
CAUTION: To prevent damage, do not soak or immerse the module in any liquid solution.
CAUTION: Do not attempt to sterilize irradiation, steam, autoclave, or ethylene oxide.
CAUTION: Do not attempt to clean the Module while monitoring patient.
CAUTION: To ensure safety, avoid placing anything on the device during operation.
Compliance Information Warnings and Cautions
WARNING: Any changes or modifications not expressly approved by Masimo shall void the warranty for
this equipment and could void the user’s authority to operate the equipment.
CAUTION: Disposal of Product: Comply with local laws in the disposal of the instrument and/or its
accessories.
Note: Use Masimo LiDCO in accordance with the Environmental Specifications section in this manual.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: For EMC compliance information, see Specifications on page 55.