Upper Half Image Alignment
To achieve the best 3D display, the Optical Head must be installed properly and aligned optimally.
Tools Required: 2mm or 5/64” hex key wrench (Type: Small Right Angle)
3. Load the standard cross-pattern image from the projector.
4. Align the Upper image lines by turning the upper horizontal alignment screw.
(Clockwise: LEFT, Counter-Clockwise: RIGHT)
5. Align the Upper image lines by turning the upper vertical alignment screw.
(Clockwise: DOWN, Counter-Clockwise: UP)
6. Check if the Upper Half Image is aligned properly as below.
To Next Page
Loading...
