Page 36 of 54 5100054 BND01O03.docx
10.18.2. Decorative Spring Arm Covers ④
See Figure 38.
Installation:
1. Insert the strap ③ of the decorative cover into the cutout ①.
2. Hook the locking pins ② of the decorative cover ④ into the mounting fixture ⑭.
3. Repeat both steps for the other decorative cover.
Disassembly:
1. Carefully unlatch a decorative cover ④ with a slotted screwdriver at the locking
pins ②. Make sure to disengage solely the decorative cover ④ and not the rear
covers ⑬.
2. Pull the strap ③ out of the cutout ① and take off the decorative cover ④.
3. Repeat both steps for the other decorative cover ④.
10.18.3. Rear Spring Arm Cover Panels ⑫
See Figure 38.
Installation:
1. Place both rear cover panels ⑫ at the spring arm and carefully engage the latches
⑪.
2. Secure each rear cover panel with two cross-recessed head screws M4x10 – 10.9
⑬ (Torx T10).
Disassembly:
1. Unscrew both cross-recessed head screws M4x10-10.9 ⑬(Torx T10).
2. Carefully disengage the latches ⑪ of both rear cover panels ⑫ and remove the
cover panels.
10.18.4. Cover Plates ⑦/⑯
See Figure 38.
Installation of Lower Cover Plates:
1. Insert the lower cover plate ⑦ into the side panels ⑨ up to the latches.
• The latches must point outwards of the spring arm.
2. Push the cover plate ⑦ forwards and manually insert the two latches ⑥ into the
two cover panels ⑫.
• Make sure, that the cover plate ⑦ runs in the groove.
3. Insert a suitable screwdriver into the hole ⑧, push the cover plate ⑦ slightly
upwards and root the snap-in hook ⑤ into the cover panels ⑫.
Disassembly:
1. Push the cover plate ⑦/⑯ slightly into the spring arm and pull them at their latches
out of the side panels ⑩.
Installation of Upper Cover Plates:
4. Insert the lower cover plate ⑯ into the side panels ⑨ up to the latches.
• The latches must point outwards of the spring arm.
5. Push the cover plate ⑯ forwards and manually insert the two latches ⑰ into the
two cover panels ⑫.
• Make sure, that the cover plate ⑯ runs in the groove.
6. Insert a suitable screwdriver into the hole ⑮ and push the cover plate ⑯ further
into the cover panels ⑫ until it audibly clicks into place.
To Next Page
Loading...
